Cooperation with colleagues in Regensburg was successful. A common article was published: „Measurement of core temperature through semi-transparent polyamide6 using scanner-integrated pyrometer in laser welding“.

A reputable journal, International Journal of Heat and Mass Transfer, published our common article
Schmailzl, J. Käsbauer, J. Martan, P. Honnerová, F. Schäfer, M. Fichtl, T. Lehrer, J. Tesař, M. Honner, S. Hierl „Measurement of Core Temperature through Semi-Transparent Polyamide 6 using Scanner-Integrated Pyrometer in Laser Welding”, Int. J. Heat Mass Transf. 146 (2020) 118814


Predicting the core temperature during welding is an ambitious aim in many research works. In this work, a 3D-scanner with integrated pyrometer is characterized and used to measure the temperature during quasi-simultaneous laser transmission welding of polyamide 6.
However, due to welding in an overlap configuration, the heat radiation emitted from the joining zone of a laser transmission weld has to pass through the upper polymer, which is itself a semi-transparent emitter. Therefore, the spectral filtering of the heat radiation in the upper polymer is taken into account by calibrating the pyrometer for the measurement task.
Thermal process simulations are performed to compare the temperature field with the measured temperature signal. The absorption coefficients of the polymers are measured, in order to get precise results from the computation. The temperature signals during welding are in good agreement with the computed mean temperature inside the detection spot, located in the joining area. This is also true for varying laser power, laser beam diameter and the carbon black content in the lower polymer. Both, the computed mean temperature and the temperature signal are representing the core temperature. In order to evaluate the spatial sensitivity of the measurement system, the emitted heat radiation from both polymers is calculated on basis of the computed temperature field. Hereby it is found, that more than 90 percent of the detected heat radiation comes from the joining area, which is a crucial information for contact-free temperature measurement tasks on semi-transparent polymers. 2019 Elsevier Ltd. All rights reserved.

Download of article here